Laguna Tools Fusion 3, Manual

Page: 19 / 40

Fusion Tablesaw
© 10/2017, Laguna Tools, Inc.
17
Adjustments
Your Laguna Tools machine comes fully adjusted from the factory, but it is good practice to double check these adjustments and make sure the
tool is in safe operating condition.
Fence Adjustments
Fitting the fence:
You will need to fit the fence to the right side of the blade to use the table saw. In the fit position, the fence can move freely with limited friction due
to the installed nylon and plastic glide bushings. The fence should not, at any times be used on the left side of the blade.
1. Un-plug the tablesaw!
2. Hold fence with both hands, with cam
lock up.
3. Place fence in fence guide
4. Check cam lock action, adjust if
necessary.
While holding the fence and the cam lock, raise
the cam lock to engage the open position. Insert
the fence frame into the front rail.
The fence can slide freely in any position to the
right of the blade. If the fence does not lock, adjust
both blade paralleling set screws (located on the
back of the fence frame as shown) at the same
rate, as needed.
Adjusting the Scale (rule):
The scale will need to be “zeroed” every time the fence guide is taken off the table or adjusted. The fence must be zeroed for accurate cuts when
using the scale.
1. Un-plug the tablesaw!
2. Position the fence up to blade.
3. Loosen the transparent viewport.
4. Adjust the view as needed
5. Tighten the view screws.
WARNING: MAKE SURE SAW IS UNPLUGGED.
With the blade in a high position, bring the fence
close to — but not touching — the blade. Use a
folded piece of paper between the blade and the
fence to ensure good distance.
Use a #2 Philips head driver to loosen (but do not
remove) the transparent scale reader. Adjust the
viewport as needed, tighten the screws. NOTICE:
If adjusting the viewport does not allow enough to
zero the scale, see step 8 of general setup.
Adjusting the Fence Glide Bushings:
You may need to adjust the height of the bushings on either side or rear of the fence. The fence should be between 1/16” and 1/8” off the table to
prevent scratches and not to allow any thin stock to slip through.
1. Un-plug the tablesaw!
2. Unlock the fence.
3. Use a hex key to adjust the front
bushing height.
4. Use a wrench to adjust the rear bushing
height.
To adjust the front bushings, use the included hex
key to raise or lower the nylon bushings that make
contact with the front fence rail.
To adjust the rear bushing, loosen the hex nut that
locks the height position of the bushing. Adjust the
position and tighten the hex nut.
2. Place fence in fence guide Check Cam lock action
Place fence in fence guide Adjust the Viewport
Front Bushings Rear Bushings