Dake Corporation
1809 Industrial Park Dr
Grand Haven, MI 49417
Part# 972016-2
10
REV#082020
Pump Rotation:
-
After making the electrical connections to the press it is necessary to make a visual check on
the direction of rotation of the electric motor.
-
Before checking the direction of rotation of the pump, fill the reservoir with oil see Fig. 6
1.
Unscrew the inspection cap.
2.
Identify a reference point on the drive shaft.
3.
Power up the motor for Max. 1-2 seconds.
4.
Check that the rotation of the shaft coincides with that of the arrow shown on the top of
the unit shown in figure 7.
5.
Screw down inspection cap.
NOTE: If the motor rotates in the wrong direction: See your electrician
.
Any damage caused by wrong electrical connection is not covered by
warrant
Electrical Connections (220V/440V):
-
This machine is dual voltage 220 3 phase / 440 3 phase. The amp rating on these machines
are 9.7 amps on 220 Volt 3 phase and 5.6 amp on 440 Volt 3 phase.
-
For proper operation it is necessary to ensure constant voltage and it must not exceed or be
lower than 5% of the rated value
-
Before making any electrical connection confirm voltage rating of the machine. There is a black
plastic box mounted on top of the reservoir
-
Remove the two mounting screws that hold this box in place. Under this box you will see one of
the following possibilities in Fig. 5. After confirming or changing this to the correct voltage mount
the cover with the two screws. Now, open the electrical panel on the transformer be sure it is
set for the correct output voltage.
NOTE:
-
Only a certified electrician that follows local and state laws is authorized to perform
any type of electrical connection on this machine. The electrical power supply voltage
must be made in compliance with local and state laws.
-
Be sure there is no power to the machine before checking the following
connections. It may be necessary to lock out the machine for proper power
disconnection.
Fig. 7