Lagrange Transparence 489, Manual

Page: 52 / 60

Lack of water: When there is not enough water
in the tank to run another cycle, the indicator light
blinks and the machine stops working. Add water
to the tank and then press the on/off button which
puts the unit in standby and turns off the “lack of
water” indicator light. To restart the unit, press the
on/off button again and select the desired ice
cube size.
MAKING ICE CUBES
STEP
1
: PREPARATION OF THE UNIT
Always put the unit on a flat, dry and uncluttered surface (leave a
clearance of
15 cm around your unit).
STEP
2
: CLEANING OF THE TANK AND THE SYSTEM
The water tank and the system must be cleaned before use.
*
To clean the tank, fill it with water (see step 3 ) then program the
unit and let the water flow (see step
4
) for
1
minute. Stop the unit
by pressing the On/Off button. Open the drain plug to remove the
wastewater from the bottom of the unit (see step
8
) and clean it
with a most sponge. Throw this water out.
*
Then plug in your unit and fill the tank with soft water (see step
3
).
STEP
3
: FILLING OF THE TANK
Fill the tank soft water, making sure that you do not exceed the
maximum level indicated by the hole.
Visuel 4
MAX
N.B. You can accelerate the ice cube making process by using very
cold water.
Be sure to change the water once a day. If the unit is not
used for a long period of time, you must replace the water.
The tank’s capacity is 2 . 5 L.
Close the cover.
52