LaGard ALTEA, Installation Manual

Page: 30 / 75

EN
3.1 Installation tools
3.2 Electrical and water requirements prior to installation
3.2.1. Power switch facility: install circuit - breaker, 32A water proof, in the
easy- operating place. Turn off the switch after use to protect the safety of
computer system (that is position “A” in the following picture)
2
3.2.2 The power socket outlet: AC220V, BV=3*4mm , 16A waterproof (that is:
the position “B” in the following picture)
3.2.3 Water supply: connect hoses (G1/2 male connector) marked with cold or
hot water supply respectively. Shut-off Valve should be installed at the end of
water supply pipe on the wall. (that is: the position of “C” in the following
picture)
3.2.4 Drain: The drain point should be just right above the end of sewage pipe
on the ground. If not, the distance between the drain point and the end of sewage
pipe should be less than 200mm. The diameter of sewage pipe under floor
should be 50mm or more. (that is the position “D” in the following picture)
3.2.5 Maintain area: Please leave space 500mm or more around the shower
room, so as to maintain conveniently in future. (that is: the shadow in the
following picture)
3.2.6 Ground Wire: Its resistance is 4Ohm or less
3.2.7 The installation height of cabin is 2400mm or more
Ø12