LAFEME CRAWFORD ST21, Instruction Manual, Page: 16 / 24

Instructions for remote control Installation
Method 1：
Method 2：
①
Install the remote controller fixing panel with a magnet on the remote control fixed seat and lock tightly
Note: Pay attention to the polarity when installing the magnet. Place the larger side of the magnet hole
outside the fixed panel and enclose the small hole surface inside the fixed panel; as shown in the below
figure 1;
②
Put the double sided tape on the remote control fixed seat；
③
Clean dust, grease, water droplets on the walls and wipe them clean；
④
Press the remote control fixed seat with double sided tape on it, Press it evenly for 3 to 5 minutes.
Attach the remote control fixed seat to the wall;
Note: The method is applicable to glazed tiles, glass and smooth wall.
Put the remote controller on the fixed base after installing the battery, and the remote controller can automatically
absorb on the fixed base.
Note: ※
Please place the remote on the fixed place if not use. (To avoid the remote falling down)
※
It may cause damage if the remote controller falls down.
※
Please do not spill water on the remote control or drop into the water, or it may cause damage.
①
Drill 2 holes (hole spacing: 46mm-52mm) and 22mm depth on the wall by the drill with the diameter
of 6mm.
Note: the position of the hole shall be satisfied when the person is seated on the seat cover. It is convenient
for the user to catch the remote control；
②
After installing the expansion plug in the wall align the fixing hole of the remote controller at the expansion
plug and then lock the bolt. Install the remote controller fixing panel with a magnet on the remote control
fixed seat and lock tightly
Note: pay attention to the polarity when installing the magnet. Place the larger side of the magnet hole
outside the fixed panel and enclose the small hole surface inside the fixed panel; as shown in the below
figure 2.
figure 1
① ② ③ ④
magnet
double
sided
tape
magnet
figure 2 ① ②
46mm 52mm
①
②
③
④
-13-