Instructions
for use
11
Electric
Kettle
EN
31 – The device should be set so that at least 1 m free space is left in front of the
device and at least 50 cm from the top and sides.
The manufacturer shall not be liable for any damage caused by improper
using of the appliance.
For security reasons, it is recommended for the electrical wiring to be equipped
with a 30 mA residual-current circuit breaker.
Note: If the power cord or the mains plug is damaged, it should always be
replaced or repaired at a specialized repair facility.
WARNINGS
1 – Never use the appliance if it is damaged or works
abnormally.
2 – Do not use the appliance if it has been dropped
from a height and shows visible signs of damage.
3 – Do not use extension cords or other electrical out
-
lets that do not meet current electrical standards and
codes.
4 – Any repair, removal or replacement of any parts
should always be performed at a specialized facility.
5 – In the event of external components such as the
electrical contacts, the plug or the cord getting wet,
make sure to dry the kettle and its elements before
use.
6 – Never handle or operate the appliance with wet
hands.
7 – If you think the appliance might be broken, NEVER
try to repair it yourself.
8 – Do not use the device in bath tub or shower, above
sink, or near any other tank with water or other liquid.
9 – Never wash the device in running water or in any
manner, which allows water to drip onto the device.
10 – Never put the device connected to mains outlet
on wet surface.
11 – Before connecting the device to mains outlet,
check whether mains parameters are compliant with
the values indicated on rating plate of the device.
II. Basic information:
1. Water filter
2. Lid
3. Lid opening button
4. Handle
5. ON/OFF switch - control panel
6. Base
7. Power terminal
8. Illuminated water level indicator
9. Plug
10. Rolled-up power cord holder
11. Water filter
III. Operation
Before use:
1 – Remove the protective film and all other elements
of the pack- age.
2 – Unwind and straighten the power cord.
3 – Fill the kettle with water up to the „Max” level 4 -
Plug the power cord into an appropriate outlet.
5 – Set the kettle at water boiling mode using button.
+–
100
°C
+–
100
°C
Set
Start
6 – Kettle interior is red illuminated and short acoustic
signal sounds.
7 – Once the water boils-discard it and repeat this pro
-
cess three more times.
Note: There may be a small amount of smoke or
odour during the first time you use the toaster but
this is normal since some heating elements might
have been covered with grease. Don’t worry, it will
disappear after some time.
Operation
1 – Connect the base into an appropriate outlet.
2 – Lift the lid of the kettle and pour water in.
3 – When pouring water into the kettle, make sure
that the water level remains within the range
between „Min” and „Max”.
Summary of Contents for no 1CEG015
Page 2: ......
Page 27: ...27 RU I 1 AC DC 2 3 4 5 6 8...
Page 28: ...28 RU 8 7 8 9 10 11 12 13 14 15 I 16 17 18 19 20 21...
Page 29: ...29 RU 22 23 24 25 26 27 28 29 30 31 1 50 30 A...