laerdal SimMom, Directions For Use Manual, Page: 41 / 50

Intr
oduction
Setup
Softwar
e
Maintenance
Spar
e Par
ts
Specifications
40 41
Maintenance
Perf
orming
Sim
ulations
5. Remove urine reservoir.
6. Lay new reservoir in position in reservoir bay, with red filler cap
on the manikin’s left, facing upwards.
7. Connect yellow Luer on urine reservoir inlet tube to yellow urine
pressurization outlet on bulkhead. (3/4 turn, do not overtighten).
8. Connect white Luer on urine reservoir outlet tube to white Luer
on urine connector tube.
9. Ensure slide clamp is open.
10. Replace reservoir cover and reconnect retaining loop and Velcro
®
strap.
Blood Reservoir Replacement
The blood reservoir is located in the reservoir bay, beneath the urine
reservoir.
To replace blood reservoir:
1. Remove reservoir cover and urine reservoir.
2. Clamp blood outlet with clamp.
3. Undo blue Luer connector from the blue bulkhead fitting.
4. Remove blood reservoir.
5. Lay new reservoir in position in reservoir bay, with red filler cap to
the manikin’s right, facing upwards.
6. Connect blue Luer connector to blue (blood pump inlet)
bulkhead fitting.
7. Ensure slide clamp is open.
8. Replace urine reservoir.
9. Replace reservoir lid.
Pelvis Replacement
To detach and replace the pelvis:
1. Turn the manikin over so that the backside is facing up.
2. Using a Phillips head screw driver, unscrew the access panel and
remove.
3. Locate the black electrical connector and two clear tubes, and
disconnect them.
– Disconnect the clear tubes by twisting the fittings.
– Disconnect the electrical connector by depressing the black
button on the side of the connector.
4. Turn the manikin back over.
5. Remove abdominal skin.
6. Using a 7/16 wrench and a Phillips head screw driver, remove the
bolts on both sides of manikin.