laerdal SimMom, Directions For Use Manual, Page: 14 / 50

14
Software
– Trend Preview Window is hidden by default. To activate, click
<Show Trends> under the Handlers dialog box. To enable at
start up, go under < Edit > on the program menu bar and click
< configuration >. On the Configuration menu screen, click
< Display parameter Trend Preview Window at startup > and
select < enabled > from the drop down menu.
9. Event Windows (3)
– Contains checklists of events relevant for the simulation. An Event
is an action (or behavior) exhibited by the user.
10. Electronic Fetal Monitoring
– View status of fetal heart rate and uterine activity.
– To view additional waveform activity, left click and hold the EFM
display and drag to the right. When the fetal monitor scroll speed
is set at 1 cm per minute, the monitor displays 60 minutes of
activity. When the fetal monitor scroll speed is set at 3 cm per
minute, the monitor displays 20 minutes of activity.
11. Instructor Monitor Control
– View status of mother’s vital signs throughout the simulation.
– Use the <
Fetal Monitor
> button to connect or disconnect the
EFM sensor to the Patient Monitor.
– Use the < Toggle Monitor > button to select which vital signs
(patient, EFM, or both) are displayed on the Patient Monitor.
– Adjust patient monitor waveforms and parameters by either
clicking the individual waveform or scrolling over the numeric
parameter readings and using the mouse wheel.
12. Simulator Controls
– View and set lungs, heart, bowels, and fetal heart sounds.
– Set vocal sounds. (View sound volume by clicking on the speakers
displayed next to the area you want to configure).
– Set seizure.
– Set lung resistance function (on/off).
– Set pneumothorax.
– Set tongue edema.
– Set boggy uterus and bleeding uterus.
– Set pulse strength.
– Pressurize urine bladder.
Editing Monitor Setup
To edit the monitor setup:
1. Click <
Edit
> in the Program Menu Bar.
2. Select < Edit Monitor Setup... > from the pull down menu.
-
To change the waveform or numeric layout, click on one of the panels
to the far left of the screen.
To change which waveforms and numeric layouts are displayed:
1. Click on one of the waveforms or numeric layouts on the large
panel in the middle of the screen.
2. Scroll over to the Available parameters menu, and select the
desired parameter.
3. Change the waveform or numeric layout by either clicking the
< Select Parameter > button or double clicking on the desired
parameter.
4. Click < Apply > to apply the changes to the Instructor Monitor
Control on the user interface.
5. Click < OK > to exit the Monitor Setup screen.
To return to the default values on a waveform or numeric layout, click
the <
Set to Default Values > button.
To download a custom layout, click the < Open Setup > button.
To save a layout, click the < Save Setup > button.
Running a Scenario
– Launch the Instructor Application.
– Click < Start Scenario >. This will open a list of scenarios.
– Select and open.
– Click < Play > button to start.
Note: < Pause > button changes to < Play > button when the
scenario is paused.
The < Pause/Play > button is located below the < Start Scenario >