6
7
To change head
- Fig. 9
To remove
When face, airway and jaw have been removed
(described in “Fig. 3”), flex the lower edges
of the head outward until the head can be
removed.
To install
Grasp the manikin head with both hands, with
your fingers on the inside of the head. Gently pull
outwards and slide the head onto the neck posts,
one side at a time.
To install the airway, face and jaw, see page 4.
Packing for transport
Place the manikin and extra accessories on one
side of the mat.
Always push the clicker lever to the “on”-position
before repacking the manikin.
Close the carrying bag.
When packing the 4-pack, position the manikins
as illustrated.
Fig. 9
ENGLISH
To remove -
Fig. 5
Open the chest cover.
Remove the rib plate.
Set the clicker in the “off”
position (outer position).
Press together the sides of
the clicker and lift it up. Push
it out through the opening in
the torso.
To install -
Fig. 6
Insert the clicker from outside
(with the pad facing upward).
Press the clicker down until it
snaps into place.
Maintenance
General manikin cleaning.
Routine disinfection of the entire manikin is not required, but periodic clean-
ing of the head, torso, chest skin, and training mat is recommended. These should be washed with a luke
warm soapy solution, and then rinsed with a clean damp cloth. Proper care will maintain the appearance
and general condition of your Little Junior.
To change clicker
To change clicker activator
- Fig. 7
The clicker activator is located underneath the
rib plate. It is fastened by snapping it in place
over the edge and into the two holes of the rib
plate as illustrated.
Fig. 5
Fig. 6
Fig. 7
To change chest skin
- Fig. 8
Unhook the chest skin from its retainers.
Fig. 8
