laerdal HeartStart FRx Trainer, Directions For Use Manual

Page: 9 / 112

9
FRx TRAINER 861307
ENGLISH
To repack the Training Pads II
1. Firmly press one pad into each side of the open training pads case.
2. Untwist the pads wires if necessary.
3. Coil the pads wires inside the case with the connector plug exiting through
the hole in the pads case.
To use the FRx Trainer with Laerdal training manikins
To simulate the patient, use the Training Pads II on a CPR training manikin equipped
with a disposable External Manikin Adapter M5089A or an Internal Manikin
Adapter M5088A. Alternatively, you can use a Laerdal Resusci Anne training
manikin equipped with Laerdal Link technology and an adapter available at most
electronics stores. Contact Laerdal for information.
To install the external manikin adapter
The M5089A External Manikin Adapter is provided with the FRx Trainer. It can be
applied to any training manikin as illustrated in steps 1 and 2 below. (When the
manikin is used in training,Training Pads II should be placed as shown in step 3
below.)
NOTE:The M5089A External Manikin Adapter has a limited service life.You can order
replacement sets of five adapters.
FRx Trainer 10-04-07 15:11 Page 9