laerdal HeartStart FRx Trainer, Directions For Use Manual

Page: 18 / 112

FRx TRAINER 861307
18
behavior possible cause recommended action
• User touched the adhesive gel on
the pads and activated the sensing
circuitry of the Trainer.
• Pad wires are twisted.
• Pad wires are not separated.
• Pads are touching each other.
• Pads placement is incorrect.
• Pads are old, damaged, or use
discontinued blue gel.
• Manikin adapter is broken.
• In scenarios 3 and 8, pad has not
been removed and repositioned.
• Pad wires are twisted.
• One of the batteries is installed
backwards.
• Trainer is stored so that On/Off
button is inadvertently pressed.
• One of the batteries is installed
backwards.
• Avoid touching the adhesive gel
on the pads.
• Untwist the pad wires.
• Separate the pad wires between
the pads and the red label.
• Separate pads.
• Check for proper pad and manikin
adapter placement. Remove and
reposition pads or adapter
if indicated.
• Replace training pads.
• Replace manikin adapter.
• Remove and reapply one pad.
• Untwist the pad wires.
• Reinstall batteries according to
the diagram in the battery holder.
• Store the Trainer so as to prevent
inadvertent pressure on the
On/Off button.
• Reinstall batteries according to
the diagram in the battery holder.
Trainer says ANALYZING
before pads are applied
to manikin.
Trainer does not say
ANALYZING when pads are
applied to the
manikin adapter.
Trainer’s voice instructions
are distorted.
Battery depletes
prematurely.
To troubleshoot the FRx Trainer
The following table provides troubleshooting tips.
FRx Trainer 10-04-07 15:12 Page 18