38
FAILURE DISPLAY AND INSPECTION
If an abnormality comes up, the induction hotplate will enter the protective state automatically
and display corresponding protective codes:
Error Message
E0
Cause:
No cookware or the cookware is not suitable for the induction cooker.
Solution:
Put the suitable cookware on the cooking zone.
E1
Cause:
The device becomes too hot (e.g. due to blocked ventilation slots)
Solution:
Clear/unblock ventilation slots. Let the device cool off for a few minutes; the
device is ready for operation afterwards. Contact the retailer in case the
error message remains indicated in the display after the device has cooled
off.
Cause:
Parts are damaged (e.g. transistor)
Solution:
Contact retailer.
E2
Cause:
Overheating-protection was activated and the device switched off.
Solution:
Remove the cookware from the hob. Let the device cool off for a few
minutes. The device is ready for operation afterwards.
E3
Cause:
Temporary overvoltage, device became too hot.
Solution:
Let the device cool off for a few minutes. The devices is ready for
operation
afterwards.
The above are the judgment and inspection of common failures.
Please do not disassemble the unit by yourself to avoid any dangers and damages to the
induction hotplate.
