3 |
LACEnano LABRYS user manual
ENG
The Obelisk adapter works with a voltage input between 4V and 8V.
Exceeding this voltage will shut the machine down. Different types of
LACENANO machines work with different voltage ranges (see table
1). Before use make sure you have set the correct output voltage
on your power supply.
Even if inside the operating voltage range
your tattoo machine may run inconsistently if to low or to high
of a voltage is set.
After everything is plugged in and you set the correct operating
voltage you have to send power to the Obelisk adapter from power
supply with your foot pedal, just like when turning on any other
tattoo machine.
*Minimum and maximum operating voltage may vary depending
on your machine settings.
WARNING: RAISING THE INPUT VOLTAGE OVER 10V WILL RESULT
IN DAMAGE TO THIS PRODUCT AND WILL VOID THE WARRANTY!
1 | Connections
2 | Usage
Figure 1
| Connections
WARNING: BEFORE FIRST USE CHECK THAT YOUR POWER SUPPLY
USES OUTPUT VOLTAGE POLARITY: POSITIVE TIP, NEGATIVE
SLEEVE. REVERSED POLARITY WILL RESULT IN DAMAGE TO THIS
PRODUCT AND WILL VOID THE WARRANTY!
Before pluging in the Obelisk adapter set output voltage on your
tattoo power supply between 4V and 8V. Plug the 1/4’’ mono plug
(Figure 1, no. 1) into your power supply. Plug one end of a standard
3.5mm stereo LACENANO cable into the 3.5mm output socket (Figure
1, no. 2) and the other and in to your LACENANO tattoo machine.
LACEnano
machine type
Magnetic*
5V
8V
Direct drive
4V
6V
Minimum
recommended voltage
Maximum
recommended voltage
