LACAVA
6
How to Use
Place hands in the sensor field
2”-4” below the spout’s tip
Warm air blows until hands are removed
or for 60 seconds of continuous operation
and then shuts down
Remove hands from sensing field
for 3 seconds to repeat the cycle
Maintenance
WARNING
DO NOT operate the hand dryer without the HEPA filter. Operating the hand dryer without the
LACAVA provided HEPA filter will void the product warranty. The H Class HEPA filter removes 99.99%
of particles as small as 0.3 µm, including dust, mold spores and most bacteria from the airflow.
It also ensures that the air flowing through the blower motor is clean and dust free. Running the
hand dryer without the filter may cause dust and small particles to be sucked into the blower, which
may shorten the service life of the motor.
A clogged-up filter reduces the air flow volume and puts unnecessary stress on the blower motor.
For relatively clean and dry environments, the HEPA filter should be replaced at least every 12 months.
For moist or dusty environments, we recommend shorter replacement intervals, e.g. every 3 - 6 months.
FILTER REPLACEMENT
1.
Unplug the power cord.
2.
Pull out the HEPA filter tray. The tray is click-locked into place with small plastic tabs on the
body of the tray. It might be tight when you try to pull it out. Pry it out gently with flathead
screwdriver wiggling it slightly side-to-side and up-and-down. Do not use brute force.
3.
Remove the tray lid, replace the filter, put the lid back on, and insert the tray back into the
hand dryer body. There will be a distinctive “CLICK”when the tray is locked into place.
4.
Plug in the power cord, and the hand dryer is back in service again.
tray cover
tray
CLICK!
