Lacava ARCH 13010, Owner'S Manual, Page: 4 / 8

LACAVA
4
Installation Instructions/Instrucciones de Instalación
1. Prepare the holes in the mounting surface (Refer to
illustration for correct sizing).
2. Remove the locking nut and foam o-ring from the
base of both the spout and the mixer.
3. Place the spout with its escutcheon into the faucet
hole in the mounting surface.
4. From below the mounting surface slide the foam o-ring
and the locking nut onto the base of the spout.
Then thread on the locking nut and tighten to the mounting
surface (DO NOT OVERTIGHTEN: This can cause damage
to the mounting surface)
5. Repeat step 4 with the mixer.
6. Connect one supply line from the faucet to the
mixer.
7. Connect the hot and cold supply lines to the mixer
handle.
8. Unscrew the top portion of the drain from the bottom.
9. Place the top portion into the drain hole and thread
the bottom portion onto the top from underneath the
sink. Connect p-trap and check for leaks.
θ 1 3/8” θ 1 1/4”
SPOUT
MIXER
OPEN
CLOSE
HOT COLD
How to Use