LACAVA LLC
®
Page 4 of 9
Installation Instructions
1.
In order to provide proper support for wall-mounting a sink, it's usually necessary
to remove a small section of drywall so you can access the wall studs and attach
blocking between them.
2.
Based on the desired mounting height, decide where support will be needed.
Then remove the drywall in that area and install 2-by-6 or 2-by-8 blocking
between the wall studs. Then using 3 1/2” galvanized common nails, toenail the
blocking to the studs and repair the drywall.
3.
If for some reason the studs cannot be used, then ¾” plywood behind the wall
can also provide the necessary support.
4.
Measure and drill four pilot holes in the reinforced wall for the anchors. Insert
anchors and secure bracket A to the wall with provided mounting bolts. Double
check to make sure that bracket A is completely level on the wall.
5.
Mount bracket B (with open end facing down) to the washbasin by following the
sequence shown above: 1 ¾” Bolt (1), small metal washer (2), steel bracket B (3),
white plastic sleeve (4), Twin Set washbasin mounting hole (5), clear plastic
washer (6), large steel washer (7), and locking nut (8).
6.
Fix steel brackets A & B together on the side of the brackets using one of the 1”
bolts in each of the four holes.
