INSTALLER’S MANUAL
INSTALLER’S MANUAL
ADJUSTMENT OF THE HOB BURNER
CHANGE OF GAS
Lacanche’s gas appliances are delivered fully adjusted in compliance with relevant regulations and
for use with the particular gas supply (type, pressure) stated in the purchase order and indicated in
the appliance’s nameplate.
Nevertheless, after connecting the appliance, the correct operation of the burners (hob and oven)
must be checked. If required, the height of the flame must be adjusted accordingly.
To do this, the gas delivery rate to the burner must be adjusted by screwing in or out the valve
adjustment screw located behind the control knob.
This adjustment is essential when changing the gas supply after having changed injectors (refer to
Section “Change of gas”).
WARNING:
The adjustment of burners must be carried out by a qualified technician.
OPERATION:
1
Push down on the control knob and turn it anticlockwise; press simultaneously on the ignition
pushbutton.
Once the burner is lit, release the ignition pushbutton.
2
Still pushing down on the control knob, set it to the small flame « »
setting.
After about ten seconds to allow for the engagement of the
thermocouple, release the control knob.
3
In the low flame setting, the flame must be low, steady and covering
slightly the tip of the thermocouple.
►If the flame goes off in the low flame setting, repeat the procedure.
If after several attempts you are unable to hold the flame in the
low flame setting, proceed to adjust the burner (refer to Section
“Adjustment of the hob burners”).
►If in the low flame setting, the flame is too strong, then the gas
delivery rate to the burner needs to be reduced.
Lacanche’s gas appliances are delivered fully adjusted in compliance with relevant regulations and
for use with the particular gas supply (type, pressure) stated in the purchase order and indicated in
the appliance’s nameplate.
The diameter of the injectors are suitable for the power of the burners and the gas supply (refer to
Table 6 in the annex).
When changing the type of gas, the injector must be changed (hob and oven burners), and the
primary air and the flow rate of the burners must also be adjusted.
CHANGING THE BURNER INJECTORS:
1
Open the table (refer to Section “Opening and closure of the gas hob table”).
2
Using a 2 mm Allen key, loosen without removing the set screw to release the injector holder.
3
Remove the injector holder from the burner.
4
Using a 7 mm key, remove the screw that holds the burner.
5
Remove the burner by pulling it towards the front and lifting its back.
8
Proceed to the adjustment of the burners (refer to Section “Adjustment of the hob burners”).
► Adjustment of the low flame flow rate.
► Adjustment of the primary air.
► Adjustment of the thermocouples.
6
Through the opening exposed after the removal of the burner,
remove the injector:
► Using a 16 mm spanner, hold the injector holder.
► Using a 12 mm spanner, unscrew the injector.
7
Replace the seal and the injector.
When refitting the injector holder, ensure that it is correctly located at the bottom of the burner.
Check the circuit for leaks.
Adjust the position of the burner to maintain the 2 mm gap between the thermocouple and the
burner.
Multicooker
Chargrill
Electric fryer
Gas burners
Induction
Ceramic Hob
Plancha
38
