Labrie Top Select, Operator'S Manual

Page: 106 / 112

Part #: 90405 97
8. Using a shovel or a broom, remove as much material as
possible.
9. Clean the rest using pressurized water.
10. Once the first partition is clean, release its locks in order to
evacuate the water (refer to “Body Partitions Adjustment”
on page 80).
11. Clean the second section. release the locks and so on,
until you reach the tailgate.
12. Lower the body.
13. Clean the body all around with water and soap.
14. Rinse.
Loading Bucket Weekly Cleaning
To clean the loading bucket(s), apply the following procedure.
Loading bucket weekly cleaning procedure:
1. Set the loading bucket in its initial position.
2. Apply the lockout/tagout procedure (refer to “Lockout/
Tagout Procedure” on page 43).
3. Remove all loading bucket partitions (see “Loading
Bucket Partition Adjustment” on page 79) and clean them
thoroughly.
4. Using a shovel and a broom, remove as much material as
possible.
5. Clean the loading bucket using pressurized water.
6. When most of of the water has been evacuated from the
bucket, put the partitions back in place.
7. If the unit is equipped with two loading buckets, repeat the
procedure for the second one.
CAUTION
B
E CAREFUL NOT TO SEND PRESSURIZED WATER ON
CYLINDER HEADS AND JOINTS OR ON ELECTRICAL
COMPONENTS SUCH AS LIMIT SWITCHES
.