LABORIE Solar Blue, Service & Installation Manual

Page: 70 / 198

© 2008
– 2020 by MMS B.V.
69
4.5.2 Solar Blue module not displayed in HW test program
The Solar Blue module is not displayed in the hardware test program (§ 4.4).
In case you use the hardware test program Bluetooth:

Register the Solar Blue module in the hardware test program Bluetooth
(§ 3.5.2).
In case you use the hardware test program (USB):

Check if the USB cable is connected between Solar Blue module and
computer.

Connect another USB cable.

Check the colours of the LED’s on the Solar Blue module.

Start the hardware test program. Select the TAB USB in the System
information.

Contact your LABORIE representative.
4.5.3 H
2
O pump icon is not displayed during investigation
The H
2
O pump is not shown in the top-left corner during the pre-test and the
investigation.

Check if the H
2
O filling method is enabled in the protocol.

Test the pump via the hardware test (§ 4.4.2).

Contact your LABORIE representative.
4.5.4 H
2
O pump is rattling
The pump is rattling. This is a result of the torque limitation of the pump
module. It will not damage the module. Starting the pump at high speeds
(125 ml/min) with a new tube may also result in a short rattling

Check if the pump tube is not folded in the pump.

Check if the flow path is not obstructed or blocked.

Check if the rollers of the pump still roll smoothly.