LABORIE Solar Blue, Service & Installation Manual

Page: 61 / 198

60 © 2008
– 2020 by MMS B.V.
Chapter 4
4.4.2 Pump Test
Choose the TAB Pump to test the pump of the Solar Blue module.
Figure 4.20 Pump test
The procedure is as follows:

Hang a bag (or bottle) of saline on the hook.

Install a pump tube in the pump.

Connect the 'input' side of the tube to the bag or bottle.

Connect the flowmeter via Bluetooth (when the hardware test Bluetooth is
used) or

Connect the flowmeter via a wired connection to an MMS-bus receptacle
(when the hardware test Solar (USB) is used). Make sure the power
adapter is connected to the Solar Blue module in this case.

Place the other side of the pump tube in the water container which is
positioned on the flowsensor. With this configuration, the 'inflow' can be
checked as the water is pumped from the bag. The flow measured by the
flowsensor can be compared to the selected pump speed.

Depending on the problem, select the desired pump speed.

Start the pump by clicking the Start pump button.