Hardware
NXT Go Owner’s Manual, LBL-00145, MAN2030
103
a.
To directly connect the PIM NXT (Figure 84) and the Roam NXT, fit the
loosened screw through the slot in Roam NXT base.
Figure 84: PIM NXT (with screw and belt clip)
b.
To use the connector cable (Figure 85), fit the loosened screw on the
PIM NXT through the slot in the cable connector and fit the loosened
screw on the cable connector through the slot in the Roam NXT.
Figure 85: PIM NXT and Roam NXT with the Connector Cable
2.
Ensure all connections are fully inserted, then retighten the screws.
6.7.2.3
Removing and Attaching the Clip
Individually press a single prong of the clip sideways across the Roam NXT until it clicks out
of the latch. Repeat with all four prongs of the clip and pull the clip away from the Roam
NXT.
To attach the clip, gently slide the prongs into their latches which will produce an auditory
click. Ensure that the clip is securely fastened before using the clip or mounting the Roam
NXT. Follow the same instructions to attach or detach the clip located on the PIM NXT
(Figure 86).
Figure 86: Removing the Roam NXT and PIM NXT Clips
Roam NXT
—Charging the Battery and Pairing
Charge the Roam NXT by using the supplied wall charger and the NXT Magnetic Pogo Pin
Cable.
Attach the binder connector to the connector on the wall charger.
Connect the wall charger to a power supply.
Attach the Magnetic Pogo Pin connector to the Roam NXT.
Status DRAFT Effective
