BA_057_en_2022-03_11.00 Electronic angle-of-rotation sensor 81.4
Page 2/5
1
General Information
This document contains necessary information for the proper installation and use of this
device. In addition to this instruction, be sure to observe all statutory requirements, applica-
ble standards, the additional technical specifications on the accompanying data sheet (see
www.labom.com) as well as the specifications indicated on the type plate.
1.1 General Safety Notes
The installation, set up, service or disassembly of this device must only be done by trained,
qualified personnel using suitable equipment and authorized to do so.
Warning
Media can escape if unsuitable devices are used or if the installation is not
correct.
Danger of severe injury or damage
Ensure that the device is suitable for the process and undamaged.
1.2 Intended Use
The electronic angle-of-rotation sensor is used for the remote electronic monitoring of pres-
sure and temperature values and can be integrated in mechanical pressure and temperature
measuring devices as specified in the data sheet.
1.3 Conformity with EU Regulations
The CE-marking on the device certifies its compliance with the applicable EU Directives for
placing products on the market within the European Union.
1.4 EX Approval
Devices of the type PL1101 are certified for use in explosive environments.
If you purchased a device with EX approval, please refer to the accompanying document
XA_009 for EX-relevant information.
2
Transportation and Storage
Store and transport the device only under clean and dry conditions preferably in the original
packaging. Avoid exposure to shocks and excessive vibrations.
Please refer to the measuring device’s operating instructions to determine the permissible
storage temperatures.
3
Installation and Commissioning
Ensure that the device is suitable for the intended application with respect to pressure range,
overpressure limit, media compatibility, temperature range and process connection.
After the mechanical installation and electrical connection is completed, the device is ready
for operation as soon as the power supply is switched on.
