BA_067_2019-05_10.00 Inline resistance thermometer
Page 2/4
1
General Information
This document contains necessary information for the proper installation and use of this
device. In addition to this instruction, be sure to observe all statutory requirements, appli-
cable standards, the additional technical specifications on the accompanying data sheet
(see www.labom.com) as well as the specifications indicated on the type plate.
1.1 General Safety Notes
The installation, set up, service or disassembly of this device must only be done by
trained, qualified personnel using suitable equipment and authorized to do so.
Warning
Media can escape if unsuitable devices are used or if the installation is not
correct.
Danger of severe injury or damage
Ensure that the device is suitable for the process and undamaged.
1.2 Intended Use
The device is intended to measure temperature in technical processes as specified in the
data sheet.
1.3 Conformity with EU Regulations
The CE-marking on the device certifies its compliance with the applicable EU Directives for
placing products on the market within the European Union.
You find the complete EU Declaration of Conformity (document no. KE_002 for GA220x or
KE_005 for GA221x) at www.labom.com.
1.4 EX Approval
Devices of the type GA2201 and GA2211 are certified for use in explosive environments.
If you purchased a device with EX approval, please refer to the accompanying document
XA_004 for GA2201 or XA_002 for GA2211 for EX-relevant information and hints.
2
Transportation and Storage
Store and transport the device only under clean and dry conditions preferably in the origi-
nal packaging. Avoid exposure to shocks and excessive vibrations.
Permissible storage temperature:
-
40…100 °C
When supplied with a transmitter the max. permissible storage temperature is reduced to
85 °C.
3
Installation and Commissioning
Ensure that the device is suitable for the intended application with respect to temperature
range, pressure range, medium compatibility and process connection.
After the mechanical installation and electrical connection is completed, the device is
ready for operation as soon as the power supply is switched on.
