2
| LABNET ROCKER 35 EZ
4.0 Installation of the Rocker
4.1 Unpacking
Before starting the installation, carefully examine the rocker for possible damage or missing parts.
Open the box and carefully remove the padding. Check that the rocker has not been visibly damaged during transportation. Keep
the packing material until you ensure that the rocker works properly.
Carefully lift the device out of the box.
Be sure that the following information is included on the serial label located on the back of the unit: serial number, catalog number,
electrical rating.
Check that the power cord plug has a pin configuration that matches a wall socket according to the local standard.
Should any kind of damage have occurred during transportation, contact the carrier immediately. The carrier is responsible for
shipping damage.
4.2 Selecting the Location
Put the rocker on a horizontal, level-, and stable surface.
Leave enough space around the rocker for normal air circulation (6 in./15 cm minimum).
Leave enough space around the rocker for easy access and maintenance.
Avoid locations subject to shocks and vibrations.
Avoid locations subject to frequent power fluctuations or power losses, as this may affect the rocker performance.
Select a location that is dry and not subject to drafts or moving air from heating or air conditioning vents or air blown by other
equipment.
4.3 Attaching the Power Cord
Connect the main power cord to the rocker and then connect the plug end of the cord to a grounded wall socket. Avoid lines to which
powerful electric motors, refrigerators, and similar devices are connected.
Be careful when you plug the cord to a grounded wall socket. Do not touch plug with wet hands. Do not pull the plug
by the cord.
5.0 Operating Instructions
5.1 Controls
2
1
3
4
5
6
1. POWER switch:
Turns the rocker ON (power switch illuminates) or OFF
2. SPEED knob:
Sets the rocker Speed
3. TIME knob:
Sets the Time of the rocker
4. HOLD yellow signal light:
Illuminates when the rocker is set for continuous running
5. START/STOP button:
START or STOP rocking
6. RUN green signal light:
Illuminates when the rocker is running