Instruction Manual |
3
6.0 Operating Instructions
6.1. Control Panel
2
1
3
4
5
6
1. POWER switch
– to turn the rocker ON (power switch illuminates) or OFF.
2. SPEED controller
– to set the shaker speed.
3. TIME controller
– to set the timer.
4. RUN –
green light illuminates when the shaker is operating.
5. START/STOP button
– to START or STOP the shaking operation.
6. HOLD function
– the yellow light illuminates and the shaker operates continuously.
6.2. Basic Operation
1. Switch on POWER.
2. Set the SPEED to the desired value.
3. Set the TIME to the desired value or to HOLD (the shaker will operate continuously and the yellow light
will illuminate).
4. Press START/STOP button to start rocking.
5. Press START/STOP button to stop rocking when in HOLD position. The device will automatically stop
after the set time when using the timer.
NOTE:
Pressing the START/STOP button during timed operation will reset the timer.
7.0 Troubleshooting
Should you have a question about the Labnet ProBlot™ Rocker 25 and 25XL or require service for the unit,
contact Corning Customer service at 800.492.1110 or 978.442.2200. Do not send the unit for service
without first calling to obtain a repair authorization (RA) number. The unit should be properly packed to
avoid damage. Any damage resulting from improper packaging shall be the responsibility of the user.
Problem
Explanation/Solution
POWER switch doesn’t illuminate
when turned ON
Check the connection to main power supply
Check fuses
Call authorized service
Rocker doesn’t start when you press
START/STOP key
Check the connection to main power supply
Check fuses
Call authorized service
