Instruction Manual |
7
NOTE:
Shaker must be in TIME mode — TIME signal must be on.
99.5
STOP
Encoder
POWER
START
RUN
TIME
RPM
Push
l l
l l l l l l l
6.0 Troubleshooting
Problem
Solution
POWER switch does not light
Check the power source.
Check fuses.
Shaker stalls – Message Er1
Power the unit down, then restart.
Display does not light
Message Er2, Er3, or Er4 on display
Contact Corning Customer Service.
Should you have a question about the operation of the Labnet Orbit™ Digital Shakers or if service is required, contact your Corning
representative. Do not send in a unit for service without first calling to obtain a repair authorization number. Should the unit require
return to Corning for service, it should be properly packed to avoid damage. Any damage resulting from improper packaging shall be
the responsibility of the user.
7.0 Maintenance and Cleaning
Before cleaning the device, unplug the main cord from the wall socket.
With the exception of the occasional maintenance described in Section 4.0 of this manual, no scheduled maintenance is normally
required. However, an experienced technician should regularly check the device operation at least once a year to make sure it is
operating correctly.
Regular cleaning of the housing is recommended.
The housing of the shaker can be cleaned with special cleaners for polyurethane (plastic) surfaces. A damp (not wet) cloth is
recommended.
NOTE:
Do not use any aggressive or abrasive cleaners (acetone, nitro, polish, etc.) because its surface can be permanently damaged.
