1. Specifications
The Labnet Mini Incubator is a compact general purpose convection incubator
capable of uniformly heating samples up to a maximum of 60C. The unit
comes with a movable shelf and has a door window area so samples can be
observed without opening the door causing heat loss.
Temperature range: a5C to 60C Controls: analog –hydraulic
Unit size w x d x h: 28.5 x 28 x 33.5 cm
Unit weight: 8.3 kg
Chamber w x d x h: 23 x 20 x 20 cm (.325 cu. ft.)
Accessories: one movable stainless steel shelf
Electrical: 115V, 50/60 Hz, 0.6 amps or 230V, 50/60 Hz. 0.3 amps
Inspect the unit and accessories thoroughly upon receipt. If any item is dam-
aged, contact the carrier immediately. The carrier is responsible for shipping
damage. Also verify that all accessories are included and that the unit is in
good working order before discarding the shipping packaging.
Your satisfaction and safety require a complete understanding
of this unit. Read the instructions thoroughly and be sure all operators
are given adequate training before attempting to put the unit in use.
NOTE: This equipment must be used only for its intended application;
any alterations or modifications will void your warranty and may cause
injury.
2. Installation
Local city, county, or other ordinances may govern the use of this equipment.
If you have any questions about local requirements, please contact the appro-
priate local agency. Installation may be performed by the end user.
2.1 Power Source
Check the data plate for voltage, cycle, wattage and ampere requirements. If
matched to your power source, plug the power cord into a grounded outlet.
Voltage should not vary more than 10% from the data plate rating.
2.2 Location
In selecting a location, consider all conditions which might effect performance,
such as heat from radiators, autoclaves, etc. Avoid direct sun, fast-moving air
currents, heating/cooling ducts and high traffic areas. Allow a minimum of
5cm between the unit and walls or partitions which might obstruct free airflow.
!
