Labgear S401, User Manual

Page: 14 / 16

14
S401 - Troubleshooting
For further information or any queries
please contact
Technical Support:
www.labgear.co.uk/support
Problem Possible Causes Solution
Display does not light
up
Power switch is not on or battery power
is low
Check to make sure meter power
switch is on
Connect to charger/mains adaptor
and make sure it is switched on
No sound or picture, but
the front panel power
light is ON.
AV IN cable connected, but no video
input
Check AV IN cable connection, check
AV source connection and signal
No sound or picture
The satellite dish is not pointing at the
satellite.
Adjust the dish. Check the Signal Level
in the Antenna Setup Menu
Bad picture/
Blocking Error
No signal or weak signal
Check the cable connections. LNB and
other equipment connected between
the LNB and the meter and adjust the
dish.
The satellite dish in not pointing at the
satellite
Adjust the dish
Signal is too strong
Connect a signal attenuator to the
LNB input
Satellite dish is too small Change to a larger dish
LNB noise factor is too high
Change to an LNB with lower noise
factor
The LNB is faulty Change the LNB
AV Out No picture
(Video)
The system is connected by SCART
cable and TV is not in AV mode.
Select rhe AV Input channel on the TV
The key is not working
Battery power is low Connect to charger/mains adaptor
Keys are blocked
Adjust the position of the meter in the
case or remove case