LM3605 Print & Apply Label Applicator
USER'S MANUAL
Page 42
Made in the U.S.A.
© 2019 LABELMILL
12/01/2019 Model LM3605
QUICK START GENERAL SETUP
1. Inspect applicator system and verify all cables are installed properly.
2. Web system with labels.
3. Turn power switch on.
4. Press “PROG”
5. Press down arrow
6. Enter Defaults
7. Press Up Arrow
8. Defaults are now set
9. Down arrow to Tamp Setup
10. Set tamp duration to .500 and set Head up switch to “N.O.”
11. Arrow down to Cycle Type
12. Set cycle type to “Tamp before feed”
13. System is now ready for set up of advanced features and options.
SETUP OF KEY FEATURES
HOW TO SET UP AN ASYNCHRONOUS APPLICATION
•
“TAMP”
Determine the following and select it in the software
1. Type of application mode. MENU “CYCLE TYPE”
2. Tamp before or after feed (before feed is standard)
3. Enter a value in the tamp duration (start with 00.500) MENU TAMP SETUP
4. Set head up limit switch, normally open is standard MENU TAMP SET UP
5. Use the product delay to “MOVE” the label on the product
The asynchronous application mode is used to apply labels to products that are either stationary or moving at a
constant speed when the label application is to take place.
•
“BLOW”
Determine the following and select it in the software
1. Type of application mode. MENU “CYCLE TYPE”
2. BLOW before or after feed (before feed is standard)
3. Enter a value in the tamp duration (start with 00.10) MENU TAMP SETUP
4. Set head up limit switch, NONE is standard MENU TAMP SET UP
5. Use the product delay to “MOVE” the label on the product
The asynchronous application mode is used to apply labels to products that are either stationary or moving at a
constant speed when the label application is to take place.
3-14
