REWINDING LABELS
•
Switch the power off.
•
Slide an empty label core over the Core
-
Holder until the core is against the inner Flange Plate. Tighten the red
knob on the end of the Quick
-
Chuck. (For the ACH please read instructions above)
LABELS EXTERNAL
•
Feed the label web from the printer over the black shaft, under the Tension Arm, and secure it to the take
-
up roll
core with tape. Rotate the take
-
up reel a couple of turns. FIG.13 and FIG.14 show the web path for standard
external rewinding. This web path will provide the best and tightest finish
-
roll.
•
Depending on your printer type (height of the output) it might be more suitable to guide the paper first under the
Tension Arm and then over the black shaft as shown in FIG.11 and FIG.16.
•
I
MPORTANT: TENSION ARM MUST BE RESTING COMPLETELY ON THE TABLE AT THIS TIME, AND NOT BE
SUSPENDED ON THE LABEL WEB.
The UNI
-
CAT will select the correct, right direction arrow based on the position
of the Tension Arm. Do not change the direction.
•
Press the START/STOP button. The UNI
-
CAT will now go automatically to its AUTO
-
START position. LED INDICATOR
START/STOP should be active together with one (1) of the direction LED INDICATORS.
•
If the 3 LED´s are flashing together, the Tension Arm was not resting on the table before starting. Restart the
device, rest the Tension Arm fully on the table and then press the start button.
LABELS INTERNAL
•
Feed the label web from the printer over the black shaft, under the Tension Arm, and secure it to the take
-
up roll
core with tape. Rotate the take
-
up reel a couple of turns. FIG.10 and FIG.15 show the web path for internal
rewinding.
•
Depending on your printer type, it might be more suitable to guide the paper first under the Tension Arm and then
over the black shaft as shown in FIG.12 and FIG.17
•
IMPORTANT: TENSION ARM MUST BE ON THE TABLE AT THIS TIME.
Now change to the opposite direction arrow
from the one that is automatically activated and press the START/STOP button. The UNI
-
CAT will now go
automatically to its AUTO
-
START position. LED INDICATOR START/STOP should be active together with one (1) of
the direction LED INDICATORS.
•
If the 3 LED´s are flashing together, the Tension Arm was not resting on the table before starting. Restart the
device, rest the Tension Arm fully on the table and then press the start button.
UNWINDING LABELS
•
Operate the UNI
-
CAT in the same way as described above for rewinding.
IMPORTANT INFORMATION / SAFETY INSTRUCTIONS
•
This product is a label Rewinder/Unwinder. It is only to be used to wind labels of the recommended dimensions
and weight in an indoor, dry environment.
•
Unplug the Winder prior to any manipulation.
•
Use on a flat surface, or mount the Winder in a fixed location using the holes in the base plate.
•
The Winder can be used in ambient temperatures of 35
º
to 105
º
F.
•
Connection of the Winder to the power source must comply with all local regulations.
User Manual
-
UNI
-
CAT
6 of 8
labelmateusa.com
