OPERATING INSTRUCTIONS
(EN)
CABLE CONNECTOR LCJ1-SK4
1 / 11
DOC001792-ML1-0 | 21.3.2019
GENERAL
This manual is part of the product.
-
Read the manual before use.
-
Store the manual for further use.
-
Please report on any discrepancies in the
manual to the manufacturer.
Labkotec reserves the right for changes of this
manual due to continuous product development.
SAFETY
The operator of the system is responsible in
terms of planning, mounting, commissioning,
operating, maintenance and dismounting.
Assembly, commissioning, operation,
maintenance and dismounting of any devices
may only be carried out by trained, qualified
personnel who have read and understood the
operating instructions.
Laws, standards, or directives applicable to the
intended use must be observed. In relation to
explosive areas, Directive 2014/34/EU must be
observed.
The devices are only approved for appropriate
and intended use. Ignoring these operating
instructions will void any warranty and absolve
the manufacturer from any liability.
The devices must only be operated in the
ambient temperature range specified.
DELIVERY, TRANSPORT AND STORAGE
Check the packaging and contents for damage.
Check that the parts are all present and correct
with respect to the order and shipping
documents.
Note the permitted storage temperature in
technical specifications.
INTENDED USE
Cable connector LCJ1-SK4 is designed to extend
sensor cables in potentially explosive
atmospheres, especially together with oil
separator alarm devices.
MOUNTING AND INSTALLATION
Detailed connection diagrams are available in the
operating instructions of sensors and control
units.
NOTE! Despite degree of protection IP68,
condensation can form in the device under
conditions of high humidity and large
temperature fluctuations. We therefore
recommend that the inside of the cable
connector be filled with gel or resin.
REPAIR AND MAINTENANCE
The devices may not be repaired, changed or
manipulated. If there is a defect, the product
must always be replaced with an original part.
DISPOSAL
Devices, packaging material, and possibly
contained batteries must be disposed of in
compliance with the applicable laws and
guidelines of the corresponding country.
