10
Product Service 1-800-522-7658
Chapter 3: Getting Started
The work surface should be at least as wide and deep as the
enclosure to properly support it. The front of the Clean Bench
should be aligned within 0.30" (8 mm) of the front of the work
surface. Mounting holes are provided in the Labconco accessory
work surfaces to secure the Clean Bench.
Work Surface Specifications
The work surface should be smooth, rigid and durable, such as a
chemical-resistant epoxy resin. The surface should be non-porous
and resistant to the materials used in conjunction with the Purifier
Vertical Clean Bench. The work surface should also contain a
dished recessed area for containing primary spills.
Vertical Clean Bench Work Surface
1.
Level the base cabinet or stand and the work surface. See
Figure 3-1.
2.
Position the work surface in its intended location and with
the front of the work surface towards you. (Rear mounting
holes are located close to the rear edge.)
3.
Secure the work surface to the base cabinet or stand with a
structural adhesive or silicone sealant.
4.
Insert the supplied mounting screws in the four holes.
Allow a minimum of 1/8" clearance under the head of the
screw for positioning the Clean Bench.
5.
Place the Clean Bench on the work surface and slide the
rear flange and front air foil flanges under the mounting
screw heads.
6.
Tighten the four screws to complete the installation.
Summary of Contents for Purifier 3970200
Page 60: ...56 Appendix C Vertical Clean Bench Specifications Product Service 1 800 522 7658 C 1 ...
Page 61: ...57 Appendix C Vertical Clean Bench Specifications Product Service 1 800 522 7658 C 2 ...
Page 62: ...58 Appendix C Vertical Clean Bench Specifications Product Service 1 800 522 7658 C 3 ...
Page 63: ...59 Appendix C Vertical Clean Bench Specifications Product Service 1 800 522 7658 C 4 ...