112
Appendix G: Acid/Formaldehyde Sensor Locations
Fan boxes that have acid or formaldehyde sensors will be labeled with small ‘A’ or ‘F’
stickers in the bottom left corner of the fan face and the carton it shipped in. The
installment locations for the sensors will be as follows:
Figure G-1
*
*
*
*
*
Key:
S
= Solvent Sensor (standard on all Fan Modules)
A
= Acid Sensor (optional)
F
= Formaldehyde Sensor (optional)
T
= Temp Sensor (standard on all Base Frames)
H
= Relative Humidity Sensor (standard on all Base Frames)
Notes:
1)
3-foot GFH: This filtered hood supports a max of (2) chemical
sensors. Available configurations are: S only, S + A, or S + F
2)
4-foot GFH: If both Molecode A and Molecode F are recommended,
Molecode A would be installed on column 2 and Molecode F on
column 1.
3)
5-foot GFH: If both Molecode A and Molecode F are recommended,
Molecode A would be installed on column 3 and Molecode F on
column 2.
4)
6-foot GFH: If both Molecode A and Molecode F are recommended,
Molecode A would be installed on column 3 and Molecode F on
column 2.
5)
8-foot GFH: If both Molecode A and Molecode F are recommended,
Molecode A would be installed on column 4 and Molecode F on
column 3.
*Molecode S cell replacement for maintenance every 5 years
Summary of Contents for Protector Airo
