Page
7
Z-PLANE Instruction Manual
V1.0
The Back Panel
A]
State indicator
B]
Frequency CV + trim controls
C]
Resonance level CV + trim controls
D]
Gain Frequency CV + trim controls
E]
Morph CV + trim controls
F]
Device Label
G]
Audio Input & Output sockets
The Audio Inputs & Outputs [G] are used to connect ZPlane to various modules within the
Propellerhead Reason environment, in a form of either an insert or a send effect.
Connecting up the audio sockets can be done automatically by Reason, or can be manually done to
your own requirements. Mono devices, when connecting a new ZPlane to them, can automatically
route their mono signal in to the left channel, and the left output of ZPlane is connected to the
originally wired socket of the mono device, closing the audio loop. Stereo devices can automatically
connect their outputs to the left and right inputs of ZPlane, and ZPlane completes the audio chain by
connecting its outputs to the originally connected stereo pair sockets.
Each audio socket processes the audio separately from each other within ZPlane. Left and right
channels never mix within ZPlane. This ensures that if you have two separate mono devices
connected to ZPlane, the settings on ZPlane affect both channels at the same time with the same
amount of effect.
The State Indicator allows you to see if the unit is ACTIVE (green), BYPASSED (red) or OFF (black, off).
This helps when cabling up what the signal chain is actually doing.
B
B
C
C
D
D
E
G
F
A