TROUBLESHOOTING GUIDE
1. Unit will not operate with power cord plugged in.
Press the ON/OFF button located on the side
2. Grinding wheel will not come out for cleaning.
Residual coffee can make the wheel stick, for severe cases use a grinder
cleaner
such
as
GRINDZ
(
www.europeangift.com
)
3. Beans will not fall into the hopper
Sometimes oils in the beans make them stick together, grasp the top
of the grinder and rock gently left to right.
4. Residual grinds are accumulating inside an area of the lower hopper.
Remove the lower hopper and clean in soapy water, rinse, dry, and
replace.
5.
When should I replace the grinding wheel?
If the grinder is used at least 3 times a week then the grinding wheel
should be replaced approximately every 18 to 24 months.
6.
Grinder has shut-off or stopped working
.
Your grinder is equipped with an auto re-set fuse. When over grinding
occurs (or excess heat is sensed) the motor will shut i self down. Turn the
unit off and allow 1-2 hours for the grinder to cool before restarting, in
the meantime the grinder should be cleaned. Follow the Cleaning After
Use instructions on page 5.
OILY BEANS
: Additional care is necessary if oily beans are used.
When grinding at fine settings (1, 2 or 3) start the grinder in the 7 to 8 position
and grind a few beans at a time, gradually reduce the setting wheel a few
numbers at a time until you reach the desired setting. Oils in the beans may
cause your grinder to jam, especially at the finer settings. Follow the
instructions under
CLEANING AFTER USE
to keep your grinder free of oil
buildup. The regular use of “Grindz” grinder cleaner is recommended every
7-8 weeks. Contact us for further information.
If you have questions concerning the operation or maintenance of this product
please e-mail us at
. Distributed by: European Gift
& Houseware, PO BOX, 111 Mt. Vernon, N.Y.
BURR GRINDER
Model- PA-8801W
Model- PA-8801B
