WS6205 Instruction Manual
about 2 seconds. This will reset all minimum and maximum data recorded to the current displayed values.
F.Y.I.:
If the temperature reading is below
ranges
, the
LL.L
will be displayed. If the temperature reading is above
ranges
, the
HH.H
will be displayed.
OUT Remote Temperature alert setting
Press and hold down the “
” button for 2 seconds until the icon for the Temperature Alert” starts to flash
The icon of Upper limit of the Temperature alarm starts to flash. Use the “+” and “-” buttons to set the
required maximum temperature. Press “
” to confirm your setting.
The icon of the Lower limit of the Temperature alarm starts to flash. Use the “+” and “-” buttons to set the
required minimum temperature. Press “
” button to confirm your setting and to end the setting
procedure
F.Y.I.:
Before entering the setup, you must select the remote channel, different channels can set different
temperature alarm range
Temperature and frost alert
Press “
” button to activate or deactivate the remote temperature alert,
When the remote temperature
alarm is activated, the temperature alarm icon is displayed in the remote sensor bar
When the remote channel temperature value exceeds the set temperature range, will activate the alarm, the
weather station will every minute continuous alarm 5 times, at the same time, temperature alarm in alarm
icon "
" flashes, If the alarm activates the temperature that is currently displayed on the channel, its
temperature value and alarm upper limit icon “
"or lower limit icon"
"
also flashes
When the temperature of remote SENSOR is –1°C to + 3°C or +30°F to + 37°F, the frost alarm will be
activated,
symbol "
" flashing.
F.Y.I.:
When the temperature is higher than the upper limit of the alarm temperature setting, the activation of the