DETAILED SET-UP GUIDE
I. BATTERY INSTALLATION
A. REMOTE TEMPERATURE SENSOR
1.
Remove the mounting bracket. The bracket
snaps on and off easily.
2.
Remove the battery cover, by sliding the cover
down.
3.
Observing the correct polarity install 2 AA
batteries. The batteries will fit tightly (to avoid
start-up problems make sure they do not spring
free).
4.
Replace the battery cover by sliding upwards.
Be sure battery cover is on securely.
B. INDOOR WEATHER STATION
1.
Remove the battery cover. To do this,
insert a solid object in the space
provided at the lower-central position
of the battery cover, then push up and
pull out on the battery cover.
2.
Observe the correct polarity, and install
3 AA batteries.
3.
Replace the battery cover.
Note: Immediately after the batteries have been installed, the LCD
(Liquid Crystal Display) will flash, and a tone will sound. Within a few
seconds the indoor temperature, indoor relative humidity, and the weather
icons (sun and clouds) will be displayed. If not, remove batteries for 10
seconds and reinstall. If the outdoor temperature is not displayed within
four minutes, remove batteries from both units, wait 10 seconds, and
reinstall making sure to install batteries into the remote temperature
sensor first. The time will show -:-- and start searching for the signal. If it
successfully receives the time signal (usually at night), it will display the
correct time (default time-zone is Eastern).You will need to adjust the time
zone to match your local time.
Battery
Cover
Battery
Cover
5
