La Crosse Technology WS-9057U-IT, Faqs

Page: 10 / 14

La Crosse Technology, Ltd. Page 10
number is for use near the coastline, the highest number is for the desert, and
middle number is for everywhere.
No WWVB Tower Icon

The forecast station has not received a WWVB time signal in the past 24-hours.

Enter the program menu to see if the display has RCC in the SET UP menu, this
must be ON to receive a signal from the atomic clock.

Position the forecast station for better reception.

Be sure you have good batteries in the Weather

Allow up to 5 nights to receive the time signal.
Dashes, OFL or Stuck Indoor Temperature/Humidity

This is generally a power related issue.

Batteries may be overpowered or underpowered. Remove batteries from
forecast station.

Press any button 20 times. Leave the forecast station unpowered for 1-2 hours.

Install fresh alkaline batteries with correct polarity.

If the indoor temperature/humidity is still dashes or OFL, the forecast station
may need to be replaced.
Inaccurate Indoor Temperature/Humidity Reading

Side-by-side test: Bring the outdoor transmitter in the house and place it next
to the forecast station for 2 hours.

Compare indoor and outdoor temperature/humidity. The temperature should be
within 4 degrees to be within tolerance. The humidity should be within 10% to
be within tolerance.

Look for heat sources such as sunlight, door or window frames, or reflected heat
of cold.
Time is off by hours

Check to see if the WWVB Tower icon appears on the forecast station. If not, the
forecast station has not received a WWVB time signal in the past 24-hours.

Reposition the Forecast station with the front or back facing Colorado.

Check that the Time Zone selected correctly reflects your location. Adjust the
time zone in the Program Menu .

Check that the DST indicator is correct for your location (most areas observe
DST so this should be ON). Adjust the DST indicator in the Program Menu.

Enter the program menu to see if the display has RCC in the SET UP menu, this
must be ON to receive a signal from the atomic clock.
Set Time Alarm

Press and hold the ALM/DATE button for five seconds. The alarm will begin to
flash to the right of the moon phase. Press and release the IN button to adjust
the hour (am or pm). Press and release the OUT/+ button to adjust the minute .
Press SNOOZE/CH to return to normal display.
Activate/Deactivate Time Alarm