Version 2 - 12/22/2011
Page 11 of 24
TX50 Outdoor Temperature Sensor
Once the forecast is showing on the WD-3303U display, insert Batteries into the outdoor sensor
and place 5-10 feet from the display for 15 minutes. Press the “PLUS” or the “SNOOZE” Key on
your Wireless Display to show the outdoor temperature.
The Wireless Outdoor Sensor sends temperature data to your Wireless Display, accurate to
within a tenth of one degree.
The Outdoor Temperature Sensor uses 2 x “AA”,
Alkaline
batteries. To install and replace the batteries, please follow
the steps below:
1. Remove the battery compartment cover on the back
of the sensor.
2. Insert the batteries, observing the correct polarity
(see marking).
3. Replace the battery compartment cover on the unit.
Press the “PLUS” or the “SNOOZE” Key on your Wireless Display to show the outdoor
temperature at any time. The outdoor temperature will scroll on the bottom of the LCD.
Hardware Installation
NOTE:
Hardware installation is only intended to be performed after you have registered
your Gateway and Wireless Display, inserted batteries into the Wireless Outdoor
Temperature Sensor, and have confirmed successful reception of weather data.
Wireless Outdoor Sensor Installation Options
NOTE:
Move the Wireless Outdoor Sensor into its intended location and wait for 10
minutes to make sure the outdoor temperature is still being received by the Wireless
Display. Press the “PLUS” or the “SNOOZE” Key on your Wireless Display to show the
outdoor temperature. If the display shows - -,-F for the outdoor temperature, the signal
cannot reach the Wireless Display. Find a closer location to mount the Wireless Outdoor
Sensor and wait 10 minutes to check the Wireless Display again for reception.
DO NOT mount the Wireless Outdoor Sensor in a permanent fashion until you are
sure the signal is being received by the Wireless Display.
To Surface Mount the Outdoor Sensor:
We have provided a mounting plate that you can attach to a surface with the
supplied screws. The Sensor can be positioned on a flat surface by securing the
stand to the bottom by gently pushing the bottom of the Sensor onto the holding
pegs of the stand until they click into place in the grooves on the Sensor.
To Wall Mount the Outdoor Sensor:
The Outdoor Sensor is weather resistant, but not water proof. To ensure maximum
Sensor life, mount it in a covered place out of the elements like under the eaves.
Placement on the North side of your home will provide the most accurate readings.
Mount it about 18” down from the eaves for optimum performance. This ensures that