14 |
P a g e
•
Press and release the SENSOR button to view the thermos-hygro sensor ID number. Compare the barcode on
your sensor to be sure they match.
•
If your temperature is reading low, and location is not an issue, you may have a bad sensor.
WHAT DOES A READING OF “HI” OR “LO” MEAN?
•
If your outdoor temperature reading shows “HI” or “LO,” check that your
•
Overpowered or underpowered batteries can cause this reading.
•
If the batteries are good, replace the outdoor sensor.
•
If your temperature is fine but your humidity is reading “HI” or “LO” or dashes, your humidity may be below
10% Relative Humidity. Your sensor does not read below 10% humidity.
TEMP INTERMITTANT: WHY DOES MY TEMP/HUMIDITY READING COME AND GO?
•
RF (radio frequency) communication may come and go occasionally. This can be normal in some environments
(e.g., moist climates).
•
If a sensor goes out, please wait 2-4 hours for it to reconnect on its own. Please be patient – these stations
can reconnect on, after many hours out.
•
RF (radio frequency) communication is not always 100% on. Certain temporary conditions can cause it to go
out for a time (e.g., 100% humidity).
If a miss happens:
•
If the sensor loses connection to the station for any reason, the station will show dashes after 30 minutes.
•
The station will search for 5 minutes every hour to reconnect with sensor.
•
Be sure you have good
. Manually search for your sensor by holding the SENSOR button for three
seconds.
Try this:
•
Bring your sensor within 10 feet of your station and make sure it is connected to the station.
•
After 15 minutes move the sensor into the next room with a wall between the sensor and the station for 1 hour.
•
If there is no loss of signal in that hour, move the sensor just outside.
•
Continue moving the sensor back to its original location.
•
If you lose connection, look for sources of
WHY AM I GOING THROUGH BATTERIES QUICKLY?
•
Test a new set of
Write down the date of installation and the voltage of the batteries.
•
When the batteries fail, please note the date and voltage again. This is helpful in determining the problem.
•
Check for leaking batteries, which may damage the sensor.
HOW DO I CHANGE BETWEEN FAHRENHEIT AND CELSIUS?
•
On your sensor, open the battery cover and press the F/C button. This will change the temperature display on
the sensor only.
•
to select Fahrenheit or Celsius temperature display on the station.
WHY ARE MY WIND CUPS NOT SPINNING?
•
Check for debris or ice preventing cups from moving.
