La Crosse Technology, Ltd. www.lacrossetechnology.com/support
Page 9
Note:
When the Adapter is NOT in use, the High/Low feature is not available.
Note:
When you
adjust the projection, you adjust the backlight
at the same time.
Battery Power:
Press and release the
SNOOZE/LIGHT button to
show the projection for 10 seconds.
The projection will
not
stay on when operation on battery power only.
Daylight Saving Time
Dependent on your location, position of the clock in your home, and atmospheric interference, it may
take up to 5 nights for the change from Daylight Savings Time to Standard Time and vice-versa to
occur.
Check for a
Tower Icon showing on your Clock. The tower icon indicates you have received
the WWVB signal from Ft Collins CO in the past 24-hours.
Check that the clock is in the correct
Check whether the DST indicator is ON or OFF. If the indicator is OFF the clock will not change.
Check for fresh
. Without proper batteries, the antenna will have a harder time picking up
the signal.
Position the Atomic Projection Alarm in a window (
with the front or back
) facing Ft. Collins, Colorado
and leave for up to five nights. If you do not have a window facing this direction, locate the Clock near
an outside wall and point the unit in this general direction.
No WWVB Tower Icon
The Atomic Projection Alarm has not received a WWVB time signal in the past 24-hours.
Position
the Atomic Projection Alarm for better reception.
Hold the
-/TIME
button to send the Atomic Projection Alarm on a signal search at night.
Allow up to 5 nights to receive the time signal.
Projection alarm is dim
Explanation:
Most projection alarms have a gray background. Place the projection alarm at eye level, to
determine if it is dim. Projection alarms that sit in the sunlight can develop a cloudy film over time.
This is generally a power related issue.
may be overpowered or underpowered. Remove batteries from projection alarm.
Press any button 20 times. Leave the projection alarm unpowered for 1-2 hours.
Install fresh alkaline batteries with correct polarity.
Projection alarm has distorted or frozen display
Explanation:
On a brand new projection alarm, check for thin plastic film of
printed scratch guard
that
may be on the screen of the projection alarm. This thin piece of plastic has printed numbers for store
displays. When the batteries are installed, the “real” numbers show behind the printed scratch guard and
create distortion.
With all power removed, the projection alarm should be blank.
If numbers still appear, please check for scratch guard.
Power:
Check that the batteries are installed correctly.
This is generally a power related issue.
may be overpowered or underpowered.
Remove batteries from projection alarm.
Press any button 20 times. Leave the batteries out of the display for 2 hours.
Insert batteries into the projection alarm.
Projection alarm is blank: No letters, numbers or dashed lines
Check that the batteries are installed correctly.
may be overpowered or underpowered.
