Page | 27
Wi-Fi Professional Station
LTV-TH2 Thermo-Hygro Sensor
1. Install 2-AA batteries according to polarity and replace battery cover.
Mounting:
1. Use the hole at the top to hang your sensor from the back using a nail. Or, insert one mounting screw
through
the front of your sensor.
2. Mount your sensor on a north-facing wall or in any shaded area. Under an eave or deck rail is preferred.
3. The maximum wireless transmission range to the weather station is up to 400 feet (121 meters) in open air,
not including walls or floors.
4. Be sure your sensor is mounted vertically, to allow moisture to drain out properly.
Note:
http://bit.ly/TH_SensorMounting
LED Light
AA
+
-
AA
+
-
Battery Cover
Hole for
mounting
TX
F/C
∙ Press TX to send a signal
∙ Press F/C to select Fahrenheit
or Celsius display on sensor.
V30v2 (328-10618)
Weather Station:
1. Insert the power cord into a wall outlet, then into your station.
Remove the red insulation tab from the CR2032 battery installed in
the bottom of your weather station to maintain time/date in the event
of a power outage.
Mounting:
1. Place your station near an outlet. Power cord is required for
operation.
2. Use the mounting holes on the back to place your station on a wall.
3. Use the pull down stand on the back of your station to place on a
desk or counter.
4. Your station should remain in good Wi-Fi range of your wireless
router to use all the remote monitoring options using the La Crosse
View app.
Power
Cord
CR2032
Battery
