20
Installation Guide - “Cornuchef” Range
Starting the appliance
IGNITION – ADJUSTMENTS
1.3. Round ceramic plates
To heat a ceramic plate with a single burner (diameter: 145
mm.), turn the knob towards the right or towards the left to
the desired position:
- 1 corresponds to the lowest position,
- 6 corresponds to the highest position,
- 0 corresponds to the shutoff position.
To heat the central burner of a ceramic plate with a double
burner and 2 zones (diameter: 195 mm.), you just have to
rotate the double-circuit simmerstat clockwise.
To ignite the 2 (outer and central) burners, turn the knob towards the right to the sign
o
o
(see the figure shown opposite) until you hear a click from the microswitch that will light
the peripheral element.
The two burners reach the maximum temperature in this position. You can then set the
temperature of the double burner by turning the control knob to any position between 6
and 1.
Note: it is impossible to only ignite the outer burner.
Please note: if the surface is cracked/fractured, immediately disconnect the appliance or the relevant
part of the supply
.
1.4. Induction plates
The 180 mm or 210 mm cooking zone adapts itself and
automatically recognizes the diameter of the pan used (120
- 250 mm) and therefore evenly distributes the heat in the
pan, thus ensuring that all of the food is cooked at the same
temperature.
Your hob’s heat settings range from 200 - 2 400 Watts for the small
burner (180 mm diameter) or
200 - 2 800 Watts for the large burner (210 mm diameter).
The maximum power for the two burners is 3 600 Watts.
You can set the power for the front burner or the back burner by turning the control knob
to the positions 1 – 6.
To stop your hob, turn the knob to the position 0 and the indicator light will then turn off.
The indicator lights provide two types of information:
1. Normal operation
When the generator is working properly, the indicator light is always on. The indicator
light flashes when not enough power can be generated. When the two indicator lights are
on, the generator is providing the two inductors with the required power.
2. Dysfunction
If the indicator light blinks as soon as the burner is turned on, that means that there is no
pan on the burner or that the pan is not suitable for an induction hob.
Please note: if the surface is cracked/fractured, immediately disconnect the appliance or the relevant
part of the supply.
0
3
1
2
4
5
6
0
3
1
2
4
5
6
single burner
double burner
0
3
1
2
4
5
6
