IGNITION – ADJUSTMENTS
31
Notice d’installation ligne “Cornuchef” Centenaire - GB
08NOTINSTGSC100/GB-4
Starting with the cooktop elements
1.3. Round ceramic plates
Warning: if the surface is cracked, immediately disconnect the device or the power supply.
To heat a ceramic plate with a single burner (diameter: 145 mm), turn
the knob towards the right or towards the left to the desired
position:
- 1 corresponds to the lowest position,
- 6 corresponds to the highest position,
- 0 corresponds to the shutoff position.
To heat the central burner of a ceramic plate with a double
burner - 2 zones (diameter: 180/110 mm), you just have to
rotate the double-circuit simmerstat clockwise.
To ignite the 2 (outer and central) burners, turn the knob
towards the right to the sign
o
o
(see the figure shown opposite) until
you hear a click from the microswitch that will light the peripheral
element.
The two burners reach the maximum temperature in this position. You can then set the
temperature of the double burner by turning the control knob to any position between 6
and 1.
Note: it is impossible to only ignite the outer burner.
The vitroceramic plates have 3 indicator lights: one at the bottom left - these come on
when a hob control is turned on and two indicator lights of residual heat (one for each
cooking areas) in the bottom right.
As long as the symbol of residual heat is on, do not touch the cooking areas and
do not place anything sensitive to heat on the ceramic glass.
1.4. Induction ceramic Hob
Induction heats up food and liquids very quickly; take care until you are familiar with it.
Warning: if the surface is cracked, immediately disconnect the device or the power supply
After use, stop the induction hob with its control knob; do not just rely on the pan detection
device.
WARNING: EVEN WHEN THE INDICATORS GO OUT, THE SURFACE MAY NOT
HAVE COOLED COMPLETELY.
DO NOT place plastic or aluminium foil, or plastic containers, on the induction
plates.
Protection in case of overheating:
the cooker is protected by a thermal safety device
that makes it momentarily unusable in case of overheating (such as when forgetting an
empty pan). Overheating causes the message “E2” to be displayed and the cooker to no
longer heat up. Once the temperature has returned to normal, the “E2” message
disappears. It will then be possible to control the cooker again.
0
3
1
2
4
5
6
0
3
1
2
4
5
6
single burner
double burner
