INSTALLATION
Check the appliance is electrically safe and gas sound when you have finished.
26
Moving the range
On no account try and move the range while it is
plugged into the electricity supply.
This appliance is heavy. Ensure you have the correct
facilities to complete the move. To find the weight of
the appliance refer to the “Technical data”.
We recommend two people maneuver the range. Make sure
that the floor covering is firmly attached, or removed to
prevent it being disturbed when moving the range around.
To help you, there are two levelling rollers at the back, and
two screw-down leveling feet at the front.
Remove the polystyrene base pack. From the front, tilt the
range backwards and remove the front half of the polystyrene
.
Repeat from the back and remove the rear half of the
polystyrene base.
Removing the door
Remove the oven door as follows: open the door fully. Swivel
the locking ‘U’ clips forward to the locking position (
).
To remove the oven door, grip the sides of the door, lift
upwards and then slide the door forwards (
) and
remove.
Lowering the two rear rollers
To adjust the height of the rear of the range, first fit a 13 mm
spanner or socket wrench onto the hexagonal adjusting
nut
. Rotate the nut – clockwise to raise – counter-
clockwise to lower.
Make 10 complete (360°) turns clockwise. Make sure you
lower
BOTH REAR ROLLERS
.
Unfold the rear edge of the cardboard base tray. Get a good
grip on the top of the oven cavity panel as you move the
oven. Carefully push the range backwards off the cardboard
base. Remove the base tray.
Position the range close to its final position, leaving just
enough space to get behind it (
).
IMPORTANT:
Remove all tape and packaging. Make sure
the burner heads are properly seated and level. Take the
accessory pack out of the oven. Check to be sure that no
range parts have come loose during shipping.
Fig. 9.4
Fig. 9.5
Fig. 9.6
Fig. 9.7
Fig. 9.8