48
49
WHAT TO DO ?
to CLEAN YoUR pR LINK
Before cleaning the device, unplug your PR LINK from the power socket. Clean the device only with a dry
cloth. Do not use cleaning alcohol or solvents to clean the device’s surface because these could damage the
painting and cause electrical failures or fire if they penetrate the device’s electronics.
No poWER
Make sure that the IEC cable is solidly connected. Make sure that the plug is fully inserted in the power socket
and there is power. Check that the master ON / OFF located underneath the loudspeaker is positioned
on “ON”. Make sure that the PR LINK is not in standby mode. Make sure that the device is switched on by
checking the Bluetooth® white LED on the top panel.
No SoUND
Make sure that the volume is turned up to audible level and that the input source is at its maximum. Make
sure that an available input source is selected. Make sure that the PR LINK is not in standby mode. Check if
the bluetooth connection with your device is still active. Finally, if you still cannot hear any sound coming out
of the PR LINK, increase the volume.
tHE SoUND IS DIStoRtED oR BUZZES
Check the connections of your music readers. Make sure that all the connecting cables are correctly plugged
in, especially the earth/protection shield connections. Make sure that your cables are in good condition.
BACKGRoUND NoISE AND UNDESIRABLE INtERFERENCES
Separate the device from other electrical appliances which may be causing the interference. If the above
solutions do not remedy your problem, please contact a professional. Your home electrical installation may
be connected to earth ground or it may be polluted by electrical parasites devices that implies audible noise.
For any repairs during or after the warranty, please contact your dealer.
tHERMAL pRotECtIoN oF tHE poWER AMpLIFIER
In case of high level extended uses, a rising temperature can alter the performance of the amplifier. Above
110 degrees, the highest level allowed for safe optimal listening conditions must be lowered until the am-
plifier cools down.
BLUEtootH® ISSUES
When connecting a new device make sure the PR LINK input source is switched to Bluetooth®. If the PR LINK
does not show up on your device make sure to manually refresh the Bluetooth® device list on your phone
/ device after rapidly pressing the PR LINK Bluetooth button. There will be a short audio signal once your
device makes connection. If you can’t hear any sound make sure the PR LINK is not in standby and turn up
the volume.
Your device may lose connection to the PR LINK when leaving the Bluetooth range or if in standby mode. In
this case Bluetooth connection can easily be made again from your phone’s Bluetooth settings page ( without
the need to press the Bluetooth button on the PR LINK).
Note that depending on your installation and your mobile device the Bluetooth range will be limited to 5-10
meters or less if walls or furniture obstruct the signal.
