Page 10
4.0 INSTALLATION
4.1
INSPECTION AND UNPACKING
The G400 has been carefully packed at our factory in a carton designed to
withstand handling in transit. Should the unit appear to have been damaged in
transit, notify your dealer immediately and do not discard any of the packing. The
carton should contain -
•
The G400
•
Power cord - country specific, please check
•
Operator Manual (this book)
4.2
OPERATING ENVIRONMENT
The G400 is designed to operate between 0°C and 40°C (32-112°F) with relative
humidity no more than 80%. Should the units be installed in an equipment rack,
ensure that the ambient temperature conforms to these levels.
4.3
CE STANDARDS AND THE LOW VOLTAGE DIRECTIVE (LVD)
The G400 has been designed to comply with the latest Electromagnetic
Compatibility (EMC) regulations. However we recommend you do not operate the
unit close to strong emitters of electromagnetic radiation such as power
transformers, motors, mobile telephones or radio transmitters.
The unit should only be connected to a power supply of the type described in 4.4
POWER REQUIREMENTS or as marked on the unit. Disconnect the mains
supply before removing any cover.
4.4
POWER REQUIREMENTS
The G400 is factory configured for either 230V 50Hz ac or 115V 60Hz ac mains
operation. Please refer to the following diagram which shows the transformer
connections for 230V and 115V –
The rating of the rear panel fuse is shown on the cover -
230V
115V
T125mA
T250mA
All are slow blow type
