MPM-1000A Operator Manual
1000-7075 Rev E
10-4
10.2 R2CP Session Tab
The session display shows multiple rows. Each row represents a possible destination
for data flow from this NCW node. A destination can be a single node (Unicast), multiple
nodes (Multicast) or all nodes (broadcast).
Refer to Table 10-2 R2CP Sessions Tab for data descriptions for this window.
Figure 10-2 R2CP Sessions Tab
Table 10-2 R2CP Sessions Tab
Control/Indicator/
Function
Description
Update
This box indicates that the R2CP sessions have changed. To update the R2CP
session, see section 10.2.
R2CP Error
This indicates an Error has been written to a trap File. See section 1.
Multicast
See section 0.
Dest Rx Role
Indicates whether the destination data flow is Unicast, multi-cast or broadcast.
Id
Session identification number assigned by the router attached to the local node.
L2 Subnets
Reserved for future use.
Mean In Bit Rate
[kbps]
A smoothed average of the bit rate sent from the router to this destination. In kilobits
per second.
Mean Out Bit Rate
[kbps]
A smoothed average of the bit rate that the local node has sent to the destination
over-the-air. In kilobits per second.
Mean Total Latency
[ms]
A smoothed average of the queuing time in the local node for this destination.
Current Data Rate
[kbps]
The current data rate this node is sending to the destination. Typically, this is the
same as the Mean Out Bit Rate. However, it is exaggerated by the Overload Factor,
and is set to 0 subject to the configurable Buffer Thresholds (in the configuration
section).
