Front Handle
Rear Handle
Axle
Wheel Support Frame
C
CP
P1
12
25
5CK
K /
/ C
CP
P1
17
70
0CK
K /
/ C
CP
P2
21
10
0CK
K
Cap Nut S
Cap Nuts L
Flange Screws
Nuts
Bushings
Wheels
Figure 4 – Component Identification
Model
CP125CK
CP170CK
CP210CK
Wheel Support Frame
Yes
Yes
Yes
Wheels
Yes
Yes
Yes
Yes
Yes
Front-Handle
Yes
Yes
Rear-Handle
Yes
Yes
Axle
Yes
Yes
Yes
Cord Wrap
Yes
Yes
Yes
Hardware Kit
Yes
Yes
Yes
Installation and Assembly Instructions
ASSEMBLY
WARNING
Fire or explosion hazard!
Do not operate heater without support frame fully
assembled to tank.
4
8
Cord Wraps
Screws
TOOLS REQUIRED
- Medium Phillips screwdriver.
- M5 open, or adjustable wrench.
1. Slide threaded axle through the rear section of the wheel support frame.
NOTE When installing wheels, tube valve should face out from support frame (Figure 3).
2. Slide one axle bushing on to each side of the axle. Slide one wheel on to each side of the axle. .
3. Attach one cap nut on to each side of the threaded axle and tighten well
4. Place heater on wheel support frame. Make sure the air inlet end (rear) of heater is over wheels. Align the holes on fuel
tank flange. Insert screws through handles (front and rear), fuel tank flange, and wheel support frame as shown in
Figure 3 and attach nut finger tight after each screw is inserted.
5. After all screws are inserted, tighten nuts firmly.
6. Align the hole on the handle (front and rear) with the mounting hole on the cord wrap.
7. Insert screws through cord wrap, handles as shown in Figure 4 and attach nut finger tight after each screw is inserted.
8. After all screws are inserted, tighten nuts firmly.
USE CAUTION WHEN INFLATING TIRES:
- Do NOT over inflate tire. Maximum air pressure is 36 PSI.
- Over inflation may lead to serious injury
- NEVER fill tires using an air compressor. A manual pump is recommended
