KARA
i
_RM_EN_1-1
w w w . l - a c o u s t i c s . c o m
15
8.
If the array is intended to be flown in pullback configuration, mount a M-BUMPi bar to the bottom KARAi as
follows:
a.
Undo the two flat-head Torx
®
screws on holes shown in Figure 10 (T30 bit).
b.
Position an M-BUMPi bar face to both holes and drive two round-head 35 mm Torx
®
screws (included in the
M-BUMPi package) (thread-locker, T30 bit, 7 N.m/63 in.lb
f
).
c.
Attach a shackle to the rear center point of the bar.
d.
Attach the hook or stinger of an additional motor to the shackle.
Refer to [9.1.3] for pullback setup safety limits.
Figure 10: Setting the array in pullback configuration
9.
Adjust the height and the site angle of the array [9.1.2].
10.
Secure the M-BUMPi to the main rigging structure using two safety slings (not included).
6.1.3
Array disassembling procedure
Apply the above procedure in the reversed sequence.
WARNING
Bottom
KARAi
a.
a.
b. c.
d.
b. c.
Summary of Contents for KARAi
Page 1: ...KARAi rigging manual EN ...
